Get connected to your switcher
VisionMix has two parts: this control page, and a small connector that talks to the ATEM. The connector runs on the show PC and also serves this page, so once it is running you are connected automatically.
- 1. On the show PC, install and run VisionMix. One installer includes the connector and the control page.
- 2. It opens this page at
http://localhost:17400and connects to the connector for you. - 3. Enter the switcher's IP below and press Connect. For a phone or tablet, open the address the connector shows (Setup → Connector has a QR code).
Working from the source repository instead? Run npm install, then npm run launch.
Transport
Local simulation runs a demo switcher in this browser. Choose Connector once the connector is running.
ATEM switcher
Enter the switcher's network address. The connector talks to it directly; no Blackmagic software is needed.
An ATEM Mini allows only one control session. Quit ATEM Software Control and any Bitfocus Companion ATEM connection before connecting here.
Status
- This computer
- unknown
- ATEM
- not connected
- Transport
- local-simulation
- Connection
- starting
- Software version
- 0.2.4
- State revision
- 0